MasterForce 15A Jobsite Table Saw Betreibershandbuch PDF herunterladen (Seite 21)

Page 20

ASSEMBLY

FIG. 26

FIG. 27

FIG. 28

USING THE RIP FENCE (FIG. 26)

1. Unplug the saw.

2. Place the front lip of the rip fence

on the front of the saw table and push

it slightly toward the back of the unit.

3. Lower the back end of the rip fence onto

the guide surfaces of the rear rail.

4. Push the locking lever down to

automatically align and secure the

fence.

USING THE MITER

GAUGE (FIG. 27)

The miter gauge provides greater accuracy

in angled cuts. For very close tolerances,

test cuts are recommended. There are two

miter gauge channels, one on either side

of the blade. When making a 90° crosscut,

use either miter gauge channel. When

making a bevel crosscut (the blade tilted in

relation to the table), the miter gauge should

be located in the slot on the right so that

the blade is tilted away from the miter

gauge and away from your hands. The miter

gauge can be turned 60° to the right or left.

Positive stops at 0° and 45° can be located

with the stop pin.

1. Loosen the locking knob and pull out

the stop pin.

2. With the miter gauge in the miter gauge

slot, rotate the gauge until the desired

angle is reached on the scale.

3. Retighten the locking knob and push

the stop pin in.

To check the angle indicator:

Loosen the locking knob and place a 90º

square against the miter gauge rod and the

miter gauge base to verify that the angle

indicator is at 0º. If it is not, loosen the

locking screw on the rod using a Phillips

screwdriver (not included) to adjust the

angle indicator to 0º, and then retighten

the locking screw.

USING THE SLIDING EXTENSION

TABLE (FIG. 28)

Locking knob

Extension table

Locking screw

Stop pin

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare