Page 11
CONTENTS
Blade guard ....................1 pc
Anti-kickback pawls ..............1 pc
Miter gauge .....................1 pc
Rip fence .......................1 pc
Push stick ......................1 pc
Blade wrench ...................1 pc
Dado throat insert ................1 pc
Hex key (15/64” (6mm) ...........1 pc
Hex key (3/16” (5mm) .............1 pc
Hex key (5/32” (4mm) ............1 pc
Bolts .........................4 pcs
Nuts ..........................4 pcs
Washer .......................8 pcs
UNPACKING
This product requires assembly.
1. Carefully lift the saw from the carton
and place it on a level work surface.
2. Inspect the tool carefully to make sure
that no breakage or damage occurred
during shipping.
3. Do not discard the packing material
until you have carefully inspected and
satisfactorily operated the tool.
4. The saw is factory set for accurate
cutting. After assembling it, check for
accuracy. If shipping has inuenced the
settings, refer to specic procedures
explained in this Operator’s Manual.
5. If any parts are damaged or missing,
please call 1-800-689-9928 for
assistance.
If any parts are damaged or missing, do not
operate this tool until the parts are replaced.
If any parts are
damaged or missing, do not operate this
tool until the parts are replaced. Failure
to heed this warning could result in
serious personal injury.
Do not attempt to
modify this tool or create accessories not
recommended for use with this tool. Any
such alteration or modication is misuse,
and could result in a hazardous condition
leading to possible serious personal
injury.
Do not connect to the
power supply until assembly is complete.
Failure to comply could result in
accidental starting and possible serious
personal injury.
Never stand directly in
line with the blade or allow hands to come
within 3” (7.6 cm) of the blade. Do not
reach over or across the blade. Failure to
heed this warning can result in serious
personal injury.
To avoid serious
personal injury, always make sure the
table saw is securely mounted to a
workbench or an approved leg stand.
NEVER operate the saw on the oor.
STAND SET-UP
The saw can be used for cutting operations
using the stand.
ASSEMBLY
WARNING:
WARNING:
WARNING:
WARNING:
WARNING:
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern