MasterForce 15A Jobsite Table Saw Betreibershandbuch PDF herunterladen (Seite 18)

Page 17

ASSEMBLY

CAUTION:

FIG. 18

FIG. 19

3. Press and hold the yellow button on the

right side of the blade guard.

4. Lower the back of the guard into the

front hole of the spreader/riving knife,

and push the guard down horizontally

until it is fully engaged.

5. Release the button to lock the guard in

place.

Lift the anti-kickback

pawls and guard up to verify that they are

locked securely.

CHECKING AND ALIGNING THE

SPREADER/RIVING KNIFE AND

SAW BLADE (FIG. 18-19)

NOTICE: Only install the spreader/riving

knife for through cuts.

If the spreader/riving knife is out of alignment

with the saw blade, adjustment is needed.

NOTICE: The spreader/riving knife alignment

can be adjusted for different blade widths.

To check the alignment of the spreader/

riving knife:

1. Unplug the saw.

2. Turn the height-adjusting handle

clockwise to raise the saw blade as high

as it will go. Remove the anti-kickback

pawls and place a framing square or

straight edge against both the saw

blade and the spreader (Fig. 18).

NOTICE: Place the framing square between

the carbide teeth, and measure from the

blade. This step will ensure that the framing

square is square against the blade from the

front to the back of the blade.

3. The saw blade and spreader/riving knife

are aligned when the framing square

contacts the blade and the spreader/

riving knife evenly with no gaps.

To adjust:

1. Unplug the saw.

2. Loosen the screws that hold the

mounting bracket with the 3/16” (5 mm)

hex key (included) (Fig. 19).

3. Reposition the blade guard assembly

to the left or right, as required, to align

the spreader/riving knife with the saw

blade.

4. Once properly aligned, retighten the

screws securely.

Screws

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare