MasterForce 15A Jobsite Table Saw Betreibershandbuch PDF herunterladen (Seite 19)

Page 18

ASSEMBLY

FIG. 20

FIG. 21

FIG. 22

CHANGING THE BLADE

DEPTH (FIG. 20)

The saw blade depth should be set so that

the outer points of the saw blade are higher

than the workpiece by approximately 1/8”

(3.2 mm) to 1/4” (6.4 mm), but the lowest

points (gullets) are below the top surface.

1. Unplug the saw.

2. Push the bevel-locking lever to tighten

it securely.

3. Raise the blade by turning the height-

adjusting handle clockwise, or lower it

by turning the handle counter-

clockwise.

CHANGING THE BLADE

ANGLE (FIG. 21)

1. Unplug the saw.

2. Loosen the bevel control by pulling

the bevel-locking lever out.

3. To adjust the bevel angle, turn the hand

wheel counter-clockwise to increase the

angle of the blade (bringing it closer to

45º); turn the hand wheel clockwise to

decrease the angle (bringing the blade

closer to 90º).

4. To lock, tighten the bevel control by

pushing the bevel-locking lever.

ADJUSTING THE BEVEL STOPS

(FIG. 22-23)

1. Unplug the saw.

2. Using a square, set the blade to

exactly 0°.

3. If the blade stops bevelling before it gets

to 0°, loosen the stop set screw (located

under the left miter guide slot) with

the 5/32” (4 mm) hex key (included), and

then adjust it to 0°.

4. With the blade set at 0°, slowly turn the

zero-stop screw until you feel

resistance. Bevel the blade away from

0° a little, and then back to the stop.

5. Re-measure the angle, and repeat the

stop adjustment as necessary until the

blade stops at 0°.

6. Set the 45° stop the same way. The set

screw for the 45° stop is located under

the right miter guide slot.

GULLETS

0°

45°

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare