MasterForce 15A Jobsite Table Saw Betreibershandbuch PDF herunterladen (Seite 14)

Page 13

ASSEMBLY

MOUNTING THE SAW TO THE

STAND (FIG. 8)

When using the table saw on the stand

provided, the table saw must be securely

mounted to the stand before use. Four

bolt holes have been provided in the

saw’s base for this purpose. Each of the

four mounting holes should be bolted

securely to the stand using the 5/16”

(8 mm) carriage bolts, washers, and nuts

(included). Tighten all four bolts securely.

Carefully check the

stand after mounting to make sure that

no movement can occur during use.

FIG. 7

FIG. 8

FIG. 9

WARNING:

STORAGE OF ACCESSORIES

The table saw has two convenient storage

areas specically designed for accessories:

the miter gauge, wrench, and anti-kickback

pawls. Store the accessories securely when

they are not in use.

REMOVING/REPLACING THE

THROAT PLATE (FIG. 9)

1. Unplug the saw.

2. Lower the blade by turning the height-

adjusting handle counter-clockwise.

3. To remove the throat plate, place your

index nger in the hole and lift the front

end, then pull the throat plate out

toward the front of the saw.

4. To reinstall the throat plate, slip the

tab into the slot at the back of the saw

and push down to secure it in place.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare