MasterForce SM3051M Spezifikationen PDF herunterladen (Seite 25)

COMPOUNDCUT(FIG. 33)

1. Extending the fence by sliding it out to the

required location or remove the right sliding

fence if necessary. See "SLIDING FENCE or

REMOVE SLIDING FENCE".

2. Set the desired bevel angle using the bevel

lock handle (1).

3. Set the desired miter angle and lock into

position. See "MITER CUT".

Fig. 33

CHOP CUTTING NARROW BOARDS=90 °

CROSSCUT (FIG. 34)

1. For a chop cutting operations on s£3..aJ.I

workpieces, slide the switch head assembly

completely toward the rear of the unit and

tighten the slide carriage lock handle (1).

2. Position the switch head to the 0° bevel

position and lock the bevel lock handle (2).

3. Position the table to the 0° miter angle and

lock the quick cam miter table lock (3).

4. Position the workpiece on the table and

against the fence. Use a hold down clamp (4)

attached to the base, whenever possible.

5. Pull the trigger (5), turning on the saw. Lower

the blade by pushing the handle (6) down into

the workpiece with slow and even pressure.

6. When the cut is complete, release the switch

and allow the blade to stop before raising the

switch head assembly.

Fig. 34

SLIDE CUTTING WIDE BOARDS UP TO

12=1/4 IN. WIDE (FIG. 35)

CAUTION

To avoid injury:

® Never pull the switch head assembly and

spinning blade toward you during the cut.

The blade may try to climb up on the top of

the workpiece, causing the cutting assembly

and spinning blade to kick back, forcefully.

The switch head assembly should be drawn

back completely then pushed forward when

sawing.

® Let the blade reach full speed before

cutting. This will help reduce the risk of a

thrown workpiece.

® Extending the fence by sliding it out to

the required location or remove the right

sliding fence if necessary. See "SLIDING

FENCE or REMOVE SLIDING FENCE".

TO SLIDE CUT WiDE BOARDS (FIG. 35)

1. Rotate the two upfront supports (7) toward the

rear of the saw.

2. Unlock the carriage lock handle (1) and allow

the switch head assembly to move freely.

3. Set both the desired bevel angle and/or the

miter angle and lock into position.

4. If bevel cutting, set both the left and right

sliding fences (2) to their proper location.

5. Use a hold down clamp to secure the

workpiece.

6. Grasp the switch handle (3) and pull the

carriage (4) forward until the center of the saw

blade is over the front of the workpiece (5).

7. Pull the trigger (6) to turn the saw on.

8. When the saw reaches full speed, push the

saw handle down, slowly, cutting through the

leading edge of the workpiece.

9. Slowly move the saw handle toward the

fence, completing the cut.

10. Release the trigger and allow the blade to

stop spinning before allowing the switch

head to raise.

Fig. 35

7

25

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 37 38

Kommentare zu diesen Handbüchern

Keine Kommentare