MasterForce SM3051M Spezifikationen PDF herunterladen (Seite 14)

MOUNTING THE MITER SAW (FIG. 9, 10)

CAUTION

To avoid injury form unexpected saw

movement:

® Disconnect the power cord from the outlet,

and lock the switch head in the lower

position using the stop latch.

® Lock the slide carriage in place by

tightening the slide carriage lock knob.

® To avoid back injury, lift the saw by using

the designated carrying handles located

on the top of the machine. When lifting,

bend at your knees, not from your back.

® Never carry the miter saw by the power

cord or by the switch handle. Carrying the

tool by the power cord could cause damage

to the insulation or the wire connections

resulting in electric shock or fire.

® To avoid injury from flying debris, do not

allow visitors to stand near the saw during

any cutting operation.

® Support the saw on a level work surface.

® Bolt or clamp the saw to its support.

Mounting instructions

1. For stationary use, place the saw in the

desired location, directly on a workbench

where there is room for handling and proper

support of the workpiece. The base of the saw

has four mounting holes. Bolt the base of the

miter saw (1) to the work surface (5), using

the fastening method as shown in Fig 9.

Fig. 9

1. Miter saw base 3

2. Hex head bolt 4

3. Rubber washer 1 _,'_

4. Flat washer

@ "

5. Workbench 5 _'

6. Flat washer

7. Lockwasher 6

8. Hex nut 7 8

9. Jam nut 9

NOTE: Mounting hardware is not included with

this tool. Bolts, nuts, washers, & screws must be

purchased separately.

2.

For portable use, place the saw

Jon a 3/4" thick piece of plywood.

Bolt the base of the miter saw

securely to the plywood using the mounting

holes on the base. Use C-clamps to clamp

this mounting board to a stable work surface

at the worksite. (Fig. 10)

Fig. 10

REMOVING OR INSTALLING THE BLADE

Removing Blade (Fig. 11,12, 13)

CAUTION

® To avoid injury from an accidental start,

make sure the switch is in the OFF

position and plug is not connected to the

power source outlet,

® Only use a 124rich diameter blade.

1. Unplug the saw from the outlet.

2. Raise the miter saw to the upright position.

3. Raise the lower clear plastic blade guard (1) to

the uppermost position. (Fig. 11 )

4. While holding the lower blade guard, loosen

the cover plate screw (2) with a Phillips

screwdriver.

5. Rotate the cover plate (3) to expose the arbor

bolt (4-Fig. 13).

6. Place the blade end wrench over the arbor bolt.

Fig. 11

7.

8.

Locate the arbor lock (5) on the motor, below

the belt cover. (Fig. 12)

Press the arbor lock, holding it in firmly while

turning the blade clockwise. The arbor lock

will then engage and lock the arbor. Continue

to hold the arbor lock, while turning the

wrench clockwise to loosen the arbor bolt.

14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Kommentare zu diesen Handbüchern

Keine Kommentare