MasterForce SM3051M Spezifikationen PDF herunterladen (Seite 13)

iNSTALLiNG THE SAFETY HOLD=DOWN

CLAMP (FIG. 5)

1. Place the hold-down clamp assembly (1) in

one of the mounting holes (2).

2. Thread the hold-down clamp knob (3) into the

holes located at the rear of the saw base.

3. Tighten the hold-down clamp knob (3).

Fig. 5

POWER CORD STORAGE CLIPS (FIG. 6)

For convenience and to prevent damage to the

power cord when the miter saw is not in use or is

in transportation, the slide carriage has two clips

on the rear for cord storage. To assembly these

clips:

1. Attach each power cord storage clip (2) to the

rear of slide-bar seat with one mounting screw

(1).

Fig. 6

CAUTION

To avoid injury, disconnect the plug from

the power source before performing any

adjustments or repair.

NOTE: Your miter saw was adjusted at the

factory. However, during shipment slight

misalignment may have occurred. Check the

following settings and adjust if necessary prior to

using this miter saw.

REMOVING AND INSTALLING THE TABLE

INSERT (FIG. 8)

CAUTION

To avoid injury:

® Always unplug the saw to avoid accidental

starting. Remove all small pieces of

material from the table cavity before

performing any cuts. The table insert

may be removed for this purpose, but

always reattach the table insert prior to

performing a cutting operation.

® Do not start the sliding compound miter saw

without checking for interference between

the blade and table insert. Damage could

result to the blade, table insert or turntable

if blade strike occurs during the cutting

operation.

1. To remove, loosen and remove the six screws

(1) on the table inserts (2) with a Phillips

screwdriver and remove the insert.

2. To install, reposition the table inserts, install

the six screws and tighten.

3. Check for blade clearance by moving the slide

carriage through the full motion of the blade in

the table slot.

Fig. 8

SAW BLADE WRENCH (FIG. 7)

For convenient storage and prevention of loss,

there is a clip (1) located at the left rear foot of

the base for storing the blade wrench (2).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Kommentare zu diesen Handbüchern

Keine Kommentare

MasterForce SM3051M Spezifikationen Seite 13

Kommentare zu diesen Handbüchern