CAUTION
To avoid injury from materials being thrown,
always unplug the saw to avoid accidental
starting, and remove small pieces of material
from the table cavity. The table insert may be
removed for this purpose, but always reattach
the table insert prior to performing a cutting
operation.
MITER CUT (FIG. 30)
The sliding compound miter saw is equipped with
ten positive miter stops (1) on the saw base. The
locations are at 0, 15, 22.5, 31.6 and 45 degrees
left and right, and 60 ° right. These locations
represent the most common angles for cutting
operation. To make a miter cut:
1. Unlock the miter table by lifting up on the
miter quick-cam table lock (2).
2. While raising the positive stop locking lever up
(3), grasp the miter handle (4) and rotate the
miter table left or right to the desired angle.
3. Release the positive stop locking lever and
set the miter at the desired angle making
sure the lever snaps into place. NOTE: The
lever will only lock into place at one of the ten
positive stops.
4. Once the desired miter angle is achieved,
press down on the quick cam miter table lock
to secure the table into position.
5. If the miter angle desired is NOT one of the
ten positive stops noted above, simply lock
the table at the desired angle by pressing
down on the quick-cam miter table lock (2).
Fig. 30
3 2 1
BEVEL CUT (FIG. 31 )
CAUTION
The sliding fence must be extended when
making any bevel cut. Failure to extend the
sliding fence will not allow enough space for
the blade to pass through which could result
in serious injury. At extreme miter or bevel
angles the saw blade may also contact the
fence.
CAUTION
The right side sliding fence must be removed
when making any right bevel angle cuts
greater than 35° in combination with any
right hand miter angle. This fence must also
be removed whenever a 45° bevel angle is
desired with a miter angle greater than 22.5 °.
Tilt the switch head to the desired angle as
shown on the bevel scale (2). The blade can be
positioned at any angle, from a 90 ° straight cut
(0° on the scale) to a 45 ° left and right bevel.
Tighten the bevel lock handle (1) by pushing
down to lock the switch head in position. Bevel
positive stops are provided at 0 °, 33.9 ° and 45 °.
Fig. 31
NOTE: The saw comes with a 33.9 ° bevel detent
pin for setting up crown molding cuts when the
_le of the walls equals 90°.
33.9 ° BEVEL DETENT PIN FOR CROWN
MOLDINGS (FIG. 32)
NOTE: A bevel detent pin is incorporated into
this machine for quick bevel adjustments when
the desired bevel angle is 33.9 °.
1. Push the bevel detent stop pin (1) in toward
the front of the machine.
2. Loosen the bevel lock handle (2).
3. Rotate the switch head until the bevel detent
pin stops the bevel angle at 33.9 ° on the
bevel scale.
4. Tighten the bevel lock handle before you
make your cut.
Fig. 32
\
24
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern