MasterForce 241-0794 Betreibershandbuch PDF herunterladen (Seite 9)

Page 8

ASSEMBLY

CONTENTS

Sander, dust-collection box, dust extraction

port, punch plate, 3pc sandpaper and

operator’s manual

ATTACHING A SANDING SHEET

(FIG. 1)

Remove the plug from the power source.

Select the appropriate sandpaper for your

job.

To attach a sanding sheet, lift the

clamping levers up and out of the base

to release the clamps at both ends of

the sanding base.

Align the holes in the sanding sheet with

those in the base, insert one end of the

sanding sheet under the clamp and close

the clamping lever, draw the sanding

sheet tight over the sanding base and

then clamp the other end.

If the sheets do not have holes, attach

as described above and use the hole

punch as described below.

The sheet should be kept tightly clamped

over the base; otherwise there could be

excessive wear of the base materials.

NOTICE: Do not continue to use the

sander with a sanding sheet that is

excessively worn or damaged.

NOTICE: Do not use the same sanding

sheet for wood and metal. Metal particles

become embedded in the sanding sheet

and will scour a wooden surface.

NOTICE: Take care to regularly clean out

the dust build up on the base underneath

the sanding sheet and do not to allow the

sanding sheet wear completely down

before replacing it.

USING THE HOLE PUNCH

(FIG. 2)

If the sanding sheet does not already

have holes, it will be necessary to punch

holes into the sanding sheet using the

hole punch provided.

Place the hole punch on a level surface.

After attaching the sanding sheet, align

the base of the sander with the hole

punch and push down on the sander

until the hole punch pierces the sanding

sheet.

Remove the sander from the hole punch.

FIG. 1

FIG. 2

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare