BLADE SELECTION
In order to obtain the best performance from the saw, it is important to select
the correct blade for the particular application and type of material to be cut.
INSTALLING AND REMOVING A SAW BLADE (Fig. 3)
1. Disconnect the saw from the power
supply.
2. Open the blade-clamp release lever.
3. Insert the saw blade into the blade
clamp as far as it will go, and release
the blade-clamp release lever to lock
the blade in position.
4. To remove the blade, open the blade
clamp release lever and pull the blade
from the clamp
WARNING! Make sure that the blade has cooled down before touching
it.
CAUTION! Test to make sure sure the blade can not be removed.
PIVOT SHOE
Sliding the Shoe In or Out (Fig.4)
For maximum control and longer blade
life, the base assembly slides in or out
to adjust the effective stroke length.
1. Disconnect the saw from the power
supply.
2. Loosen the shoe-release screws with
the hex wrench (supplied), and slide the shoe to the desired position.
3. Tighten the shoe-release screws to lock the shoe firmly in place.
Pivoting the Shoe (Fig.5)
The shoe pivots in order to provide
maximum control against the surface
being cut.
ORBITAL-ACTION ADJUSTMENT (Fig.6)
The orbital-action lever has two
positions. “0” selects normal cutting
without orbital action. “1” selects
orbital action and causes the blade to
ORBITAL FUNCTION
The orbital action thrusts the blade forward on the cutting stroke and greatly
increases the cutting speed compared to the normal up-and-down blade
action.
WARNING: To avoid injury and damage, do not operate the saw without the
pivot shoe in place. The spindle may strike against the workpiece and damage
the reciprocating mechanism.
ASSEMBLY AND ADJUSTMENT
WARNING! Your saw should never be connected to the power source
when you are assembling parts, making adjustments, installing or removing
blades, cleaning, or when it is not in use. Disconnecting the reciprocating saw
will prevent accidental starting, which could cause serious personal injury.
ON/OFF SWITCH, VARIABLE-SPEED CONTROL AND LOCK_ON BUTTON (Fig. 2)
Your reciprocating saw is equipped with
a trigger switch to turn the saw on and
off and to control the speed.
1. To start the saw, squeeze the trigger
switch.
2. To stop the saw, release the trigger
switch and allow it to return to the
“OFF” position.
3. To lock the on/off switch in the “ON”
position, squeeze the trigger switch and, while holding it “ON”, press
in the lock-on button. This feature is convenient for continuous sawing
applications.
4. To unlock the on/off switch, squeeze and release the trigger switch without
depressing the lock-on button.
5. To vary the speed, simply increase or decrease the pressure on the trigger
switch. The more tightly the trigger switch is squeezed, the higher the
speed.
WARNING! If the “lock-on” button is continuously depressed, the trigger
cannot be released and the tool cannot be turned off.
LED WORKLIGHT
Your reciprocating saw has a built-in LED worklight for illuminating the
cutting area. To activate the LED worklight, plug in your reciprocating saw
and depress the trigger switch.
Fig.2
Fig.3
Fig.4
Fig.5
(28 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern